Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in plastic and polyvinyl chloride pipe (PVC) by using our brand woodworking auger bits?
A: No, it is not recommended, it has a screw at the head point.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.28 Hex Shank…

    Q: Can I make screw threads on aluminum material? A: Yes. But aluminum material is quality of being tenacious, so…
    FAQ

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ

  • 2021.05.18

    No.36 Mushroom …

    Q: If I want to make a further depth hole by using Mushroom Hammer, how I can make it? A:…
    FAQ

  • 2021.05.18

    Pliers

    Precautions for using our brand pliers. Please make sure the wire size, crimp terminal size and tool size, etc. If…
    Attention