Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in rubber by using our brand woodworking auger bits?
A: No, it is not recommended, it has a screw at the head point.

OTHEROther【FAQ】articles

  • 2021.05.18

    No.28 Hex Shank…

    Q: What are the differences in the type of Hex Shank Taps of our products between No.28, No.28S, and No.28P?…
    FAQ
  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention
  • 2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in autoclaved lightweight concrete panels (ALC) by hex shank siding drill bits (Carbide tool)?…
    FAQ
  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in the siding board with our brand hex shank drill cutter? A: Yes. But,…
    FAQ
  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in plastic and polyvinyl chloride pipe (PVC) by using our brand woodworking auger bits?…
    FAQ