Tips

FAQ

No.51 Hex Shank Siding Drill Bits

Q: Can I make a hole in autoclaved lightweight concrete panels (ALC) by hex shank siding drill bits (Carbide tool)?
A: Yes, it is possible.

OTHEROther【FAQ】articles

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in rubber by using our brand woodworking auger bits? A: No, it is not…
    FAQ
  • 2021.05.18

    No.22 Hex Shank…

    Q: Why does the hole size of making by our hex shank dowel bits make small to compare of actual…
    FAQ
  • 2021.05.18

    No.20 Hex Shank…

    Q: Is there one point tip to advise for making a big hole by using the iron drill bits, stainless…
    FAQ
  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention
  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in stainless steel by using our brand hex shank drill cutter? A: No, it…
    FAQ